Hi everyone!
Had a good look underneath the bike this week, and the exhaust at one point has a crack in the weld (lot of rust down there - part of all the TLC my T needs). It's running fine, but if I don't address this I know it'll be trouble down the line. So here's the question:
Will JB weld do the trick? Do I first use some steel wool (if so, what's the best gauge for this), and then apply JB weld? I gather it has a necessary drying time - what is that? Has anybody else gone that route, and what were the results? Thanks so much you guys!!!
Glenn
Had a good look underneath the bike this week, and the exhaust at one point has a crack in the weld (lot of rust down there - part of all the TLC my T needs). It's running fine, but if I don't address this I know it'll be trouble down the line. So here's the question:
Will JB weld do the trick? Do I first use some steel wool (if so, what's the best gauge for this), and then apply JB weld? I gather it has a necessary drying time - what is that? Has anybody else gone that route, and what were the results? Thanks so much you guys!!!
Glenn
